Beyond the Studs: Mastering Metal Framing Quality Control

By -

Metal Stud Framing 



1. Are the metal studs the correct gauge? Check the drawings.

2 Are the metal studs the correct size?

3. Are the metal studs and drywall stored in a dry place?

4. Verify that the door jambs are double-studded. 



5. Verify that the correct metal stud size and gauge are used on the exterior wall. (16 gauge, 6" or 8")



6. Verify that the bottom plate is securely fastened to the floor and anchored with the correct fasterers. 

7. Verify that the metal studs are plumb.


8. Verify if control joints are to be installed in the wall. Check the wall length with the code.

9. Verify the location of nailing strips and blocking. 



10. Verify that all the studs are 16" on center or per the drawings. 

11. Verify that the bracing is installed, if necessary, per the drawings. 


Shettig Construction Management provides Professional Construction Management services from the inception of your project through completion. www.shettig.com

mshettig@gmail.com



Comments

Post a Comment

Popular Posts

Built to Last: The Essential Quality Control Checklist for Pre-Engineered Metal Buildings (PEMB)

By -
Image
   Pre-Engineered Metal Building      Structural Inspections Crane Setup and Location Meet with your crane operator and review a lifting plan before work commences. Consider all the aspects of the lift; 1)      Weight 2)     Center of gravity 3)     Lifting points on the load 4)     The path that the load will travel during the lift. 5)     Review the capabilities of the crane, review the load tables, or the instrument of loading. 6)     Consider the wind 7)     Communication during the whole process of the lift. 8)     Are the outrigger pads a sufficient size?   Perform a bearing capacity check by a geotechnical engineer for any crane or concrete pump truck outrigger used on the project. Set up a sequence plan for the erection of the building 1) Are all anchor bolts washered and properly nutted? 2)  Is the...
Read more

The Deadly Setup: What a Dallas Crane Tragedy Teaches Us About Construction Safety

By -
Image
  Crane mishap kills one on Dallas School project My Geotechnical firm investigated the crane collapse. They reviewed the soil conditions under the crane and found that the soil had sufficient strength and compaction. However, for your projects, perform a bearing capacity check by a geotechnical engineer for any crane or concrete pump truck outrigger that will be used on the project. Shifting Center of Gravity The geotechnical investigation determined that the crane was overloaded.  The center of gravity is vital in operating a crane. When operating a crane, a crane operator should always ensure that the center of gravity is maintained within the crane’s body to avoid crane overturn. Meet with your crane operator and review a lifting plan before work commences. Consider all the aspects of the lift; 1)      Weight 2)     Center of gravity 3)     Lifting points on the load 4)     The path that the load will ...
Read more

Build Faster, Smarter: Is the Design-Build Method Right for Your Project?

By -
Image
The Design-build method on your construction project versus the traditional Design, bid, build method. Project: Huntsman Chemical Computer Building Addition, Conroe, Texas  I met Huntsman in mid-August and reviewed their completed drawings for the project.   They required that their project be complete by December 1 st . Their design showed a 44’ x 40’ painted block addition, one story along with bar joists and a structural steel deck with poured concrete and a gable steel frame roof with metal roof panels.                                  Bar joists with metal deck and poured concrete deck. METAL BAR JOISTS SCHEDULE PROBLEM Bar joists require a 10–12-week delivery after the shop drawing review. This puts the delivery in early December. Their design is a 7-month schedule project, not the 3 months that they desired. REDESIGN OF THE PROJECT TO A STRUCTURAL STEEL FRAMING I discussed with them t...
Read more